New

Cekol Q3 Max Fibergel Adhesive

New

CEKOL Q-3 MAX is a cementitious adhesive (C) with improved technical parameters (2), with reduced slip (T) and extended open time (E), C2TE 

PRICE PER 20 KG BAG

More details

17,24€

More info

It is used for tiling gres, ceramics, stone and glass tiles, as well as mineral wool to concrete substrates, bricks, cellular concrete, expanded clay aggregates, plaster boards and blocks, drywalls, stable wood-based substrates and steel structures. Thanks to double fiber strength, new tiles can be applied on the old ones without hacking off. The product can also be used for skimming and surface levelling. CEKOL Q-3 MAX is a highly flexible, frost- and water-resistant adhesive for indoor and outdoor use. Tiles can be applied from top to bottom. Recommended for heated surfaces.

SUBSTRATE PREPARATION

The substrate should be clean, compact and free of grease. All residues of emulsion and oil paints and loose grains of sand should be removed with a spatula or a rough brush.

PRIMING

Strongly absorbent substrates should be primed with deeply penetrating CEKOL DL-80 primer.

ADHESIVE PREPARATION

The adhesive should be prepared by pouring 1 kg of powder into 0.22 – 0.24 l of water (4.4 – 4.8 l of water per 20 kg bag), and then thoroughly mixed with a slow-rotating mixer until a uniform consistency is obtained. Wait approx. 3 minutes and mix thoroughly again. Pot life: around 3 hours.

APPLICATION

Apply the adhesive to the prepared substrate with a notched trowel. In the case of heated surfaces, turn off the heating before tiling. Heating can be switched back on after at least 7 days. For outdoor use or for better adhesion in the case of highly absorbent or gres tiles, the CEKOL Q-3 MAX adhesive should be applied in a continuous layer on both the substrate and the underside of the tiles.