New
CEKOL Q-4 PLUS is a deformable (S1) cementitious adhesive (C) with improved technical parameters (2), with reduced slip (T) and extended open time (E), C2TES1. Thanks to its special hydrophobic additives, it is recommended especially for ceramic linings in swimming pools, fountains, balconies and terraces
PRICE PER 20KG BAG
Availability date:
t may also be used for ceramic, gres, stone and glass tiles as well as mineral wool and foamed polystyrene elements to bricks, concrete, aerated concrete blocks, expanded clay blocks, plaster boards and blocks, drywalls and stable imitation wood substrates. CEKOL Q-4 PLUS can also be used for skimming and levelling. Recommended for heated surfaces
SUBSTRATE PREPARATION
The substrate should be clean, compact and free from grease. All residues of emulsion and oil paints and loose grains of sand should be removed with a spatula or a rough brush.
HYDRO-INSULATION LAYER PREPARATION
To ensure water-tightness, it is necessary to use one-component sealant CEKOL ZU-1 or two-component sealant CEKOL ZU-2.
ADHESIVE PREPARATION
In order to prepare the adhesive, pour 1 kg of powder into 0.23-0.25 l of water (4.6-5 l per 20 kg bag) and mix thoroughly with a slow-rotating mixer until a uniform consistency is obtained. Wait around 3 minutes and mix thoroughly again. Pot life: around 3 hours.
APPLICATION
Apply the adhesive to the prepared substrate with a notched trowel. When working on heated surfaces, switch the heating off before tiling. Heating can be switched back on after at least 7 days. When used with highly absorbent and gres tiles, the CEKOL Q-4 PLUS adhesive should be applied in a continuous layer on both the substrate and the underside of the tiles for better adhesion. A hydro-insulation layer should be applied to places exposed to water leakages.