Cekol Gs100 Gypsum Plaster 1-10mm

APPLICATION AND PROPERTIES:

• CEKOL GS-100 is used for filling of defects and cracks in mineral substrates, as well as smoothing of walls and ceilings inside buildings.
• CEKOL GS-100 is a mixture of synthetic gypsum, mineral fillers and modifying additives.

PREPARATION OF THE SUBSTRATE:

Using a spatula, remove the remains of emulsion and oil paints, and loose grains of sand. The substrate should be clean, tight and free of grease.

GROUNDING:

Highly absorbent substrates should be primed with a deep penetrating priming emulsion CEKOL DL-80.

PREPARATION OF THE MORTAR:

The mortar should be prepared by pouring 1 kg of powder to approx. 0.45 liters of water. Leave for 2 minutes, then mix thoroughly until a uniform thick mixture is obtained.

APPLICATION OF THE PLASTER COMPOUND:

The product should be applied to the surface using tools made of stainless steel. The mortar should be used within 60 minutes. Capacity ~1.5 kg/m2/mm. Layer thickness 1-10 mm. Temperature of application and substrate +5 ÷ +25°C.

FURTHER WORK:

After the initial hardening, it is possible to make adjustments using a sanding screen or sandpaper. Painting or wallpapering can be started when the surface is fully dry.